Calculate the density in grams per cubic centimeter of a material that has a mass of
720 milligrams and a volume of 10.0 cubic centimeters. =

Answer:

B, 6

Explanation:

Answer: A sea of electrons

Explanation:

Answer:

Mass =  117 g

Explanation:

Given data:

Moles of water = 6.50 mol

Mass in gram = ?

Solution:

Formula:

Number of moles = mass/molar mass

Molar mass of water = 18 g/mol

Now we will put the values in formula.

6.50 mol = mass/ 18 g/mol

Mass = 6.50 mol×18 g/mol

Mass =  117 g

Answer:

Explanation:

CaCO₃     +     2HCl     →      CaCl₂    +    CO₂       +       H₂O

100 gm  +  2000 mL of M HCl

Amount of HCl remaining = .1018 M of 16.62 mL

= .1018 x 16.62 mL of M HCl

= 1.69 mL of M HCl

Initial HCl taken = 50 mL of .1035 M HCl

= 5.175 mL of M HCl

HCl reacted = 5.175 - 1.69 mL of M HCl

= 3.485 mL of  M HCl

2000 mL of M HCl reacts with 100 gm of CaCO₃

3.485 mL of M HCl will react with .174 grams of CaCO₃

percentage of calcium carbonate = .174 x 100 / .2027

= 85.84 %

Answer:

Elements can be chemically combined into compounds, therefore, a compound consists of two or more elements combined, in definite proportions, by chemical means. Compounds may be formed by combining atoms of their constituent elements by ionic bonds or by covalent bonds.

Answer:

The farthest habitable spot to the south  The whole distribution system broke down.

Explanation:

Answer:

Gay-Lussac's law.

Explanation:

According to Gay-Lussac's pressure law, it states that the pressure of a given mass of gas is directly proportional to the absolute temperature of the gas, the assumption that the volume is kept constant.

Hence, the trucker's tires were blown up because they were under high pressure as he drove from New Jersey to California, as a result of this intense pressure the temperature of the air in the tires began to rise and it directly affected the pressure of the gas in the tires' tubes which also increased to a point that they ended up blowing out, obeying Gay-Lussac's law.

Answer:

150000 degrees

Explanation:

Answer:

Concentration of the detergents

Explanation:

The factor that changes the reaction is the concentration of the reacting detergent.

Here are some factors that influences the rate of reaction;

The reaction rate is directly proportional to the concentration of the reactants.

Here since we have a more concentrated detergent, its reaction rate will be higher than normal and it will wash better.

Answer:

Particle energy

Explanation:

Answer:

D

Explanation:

+1

If sodium loses an electron, it now has 11 protons, 11 neutrons, and only 10 electrons, leaving it with an overall charge of +1. It is now referred to as a sodium ion.

Answer:

b

Explanation:

kkkk(kkkkkkkkkkkkwritten am an ah roo ero di si di dh dh ah ah eh si eri di do

Answer: the answer is B. C

Explanation:

Mass of Nd₂(SO₄)₃ : 2.653 g

Reaction

Nd₂Fe₁₄B + 17H₂SO₄ → Nd₂(SO₄)₃ + 14FeSO₄ + B + 17H₂

5 g Nd₂Fe₁₄B

MW = 2. 144,242 + 14. 55.845 + 10.811

MW = 288.484 + 781.83+10.811=1081.125 g/mol

mol :

[tex]\tt mol=\dfrac{mass}{MW}\\\\mol=\dfrac{5}{1081.125}=0.0046[/tex]

mol Nd₂Fe₁₄B = mol Nd₂(SO₄)₃=0.0046

so mass of Nd₂(SO₄)₃ :

MW Nd₂(SO₄)₃ = 2.144.242+3.32,065+12.15,999

MW = 288.484+96.195+191.988=576.667 g/mol

[tex]\tt mass=mol\times MW\\\\mass=0.0046\times 576.667\\\\mass=2.653~g[/tex]

Answer:

box A

Explanation:

10 is bigger than 3 since 10 is bigger it has more force in it

1. 0+15+30+45+60=150/5=30 s

0+10+16+22+27=75/5=15 cm^3

then, 15/30= 0.5 cm^3/s(average rate of rxn)

2. 0+15+30+45+60+75+90+105+120=540/9=60 s

0+10+16+22+27+31.50+36+39.5+42=224/9=24.89cm^3

then, 24.89/60=0.414cm^3/s (avrg rate of rxn)

3. overall rxn add all the time divide by 12 and the volume add them too and divide by 12. after take average volume divide by the average time to get the average rate of overall rxn

4. 16/30= 0.533cm^3/s

5. 39.5/105= 0.37cm^3/s

Answer:

300.9mL

Explanation:

Given parameters:

V₁  = 280mL

T₁ = 22°C

T₂  = 44°C

Unknown:

V₂ = ?

Solution:

To solve this problem, we apply Charles's law;

  it is mathematically expressed as;

            [tex]\frac{V_{1} }{T_{1} } = \frac{V_{2} }{T_{2} }[/tex]

We need to convert the temperature to kelvin;

       T₁ = 22°C = 22 + 273 = 295K

       T₂  = 44°C = 44 + 273  = 317K

Input the parameters and solve;

        [tex]\frac{280}{295}[/tex]   = [tex]\frac{V_{2} }{317}[/tex]

  V₂ x 295 = 280 x 317

  V₂ = 300.9mL

Answer:

=8 atoms

Explanation:

In (NH4)2C2O4 there are four moles of Hydrogen in the compound (NH4), but there two molecules of (NH4) in this compound.  That's what the 2 in (NH4)2 means, so multiply 4 x 2 = 8.

Hope this helps (:

Answer:fluorine

Explanation:

Answer:

Element Helium have 2 energy levels.

Explanation:

HELIUM - With the symbol He and the atomic number 2, helium is a chemical element. It is a colorless , odorless, tasteless, non-toxic, inert, monatomic gas that is the first in the periodic table in the noble gas group. Of all the elements, its boiling point is the lowest.

At about 24 % of the total elemental mass, which is more than 12 times the mass of all the heavier elements combined, it is present. In both the Sun and Jupiter, its abundance is identical to this. This is due to helium-4's very high nuclear binding energy (per nucleon) with respect to the next three elements following helium.

Hence , the answer is 2 energy levels in Helium atom.

Answer:

313.5cm²

Explanation:

Given parameters:

Weight of model  = 105pounds

Pressure applied on the scale by model = 2.16pounds per square inch

Unknown:

Area of her feet in cm² = ?

Solution:

Pressure is the force per unit area;

     Pressure  = [tex]\frac{Force}{Area}[/tex]

Input the parameters and solve;

                2.16  = [tex]\frac{105}{Area}[/tex]

       105  = 2.16 x Area

        Area = [tex]\frac{105}{2.16}[/tex]   = 48.6in²

We need now to convert the in² to cm²

          1in² = 6.45cm²

        48.6in² = 48.6 x 6.45  = 313.5cm²

Answer: The answer would be 158,200

Answer:

when lit, the atoms of different chemical compounds inside the firework absorb energy, when the electrons fall back to lower energy levels, they give off colored light. Depending upon the chemical used, different colors are produced. neon lights or signs are glass tubes filled with neon gas. When the light is plugged in, the electrical energy causes the electrons of neon to jump to higher energy levels, when they go to lower levels, colored light is given off. The neat thing is that the neon never gets used up. The only thing that gets used up is the electricity. The electrons don't get destroyed and can be used over and over again jumping levels. Neon glows with an orange light, but you know that neon signs can be lots of different colors. The variations come when different gases other than neon are used such as argon, or krypton or when the tube is painted so that with the light produced it produces a certain color.

Explanation:

After being excited by high levels of electrical energy (as in neon signs) or heat energy, various elements and molecules will emit their own specific colors of light.

Metals burn in a variety of colors. When a copper compound is lit, for example, the flame is blue-green.

Calcium burns red, while potassium burns purple. Metals are combined to produce various colors in fireworks.

The appearance of each firework is determined by the type of stars it contains, as well as the size and quantity of these pellets.

Some stars contain metal salts, which produce brilliant colors, while others contain a variety of chemical compounds that produce dazzling light effects such as strobing, sparkling, and others.

Various elements and molecules will emit their own specific colors of light after being excited by high levels of electrical energy (as in neon signs) or heat energy (as in the fireworks).

Thus, the neon signs or fireworks provide different colors.

For more details regarding fireworks, visit:

https://brainly.com/question/16737516

#SPJ2

Answer:

A

Explanation:

Because it got smaller so that mean it had a chemical reaction

Answer:

No

Explanation: Neither has the dominant trait for Widow's peak, so they're both aa

Answer:

Explanation:

The mass of a substance when given the density and volume can be found by using the formula

From the question

volume = 5 mL

density = 1.5 g/mL

We have

mass = 1.5 × 5

We have the final answer as

Hope this helps you