Answer: true
Explanation:
Answer:
true
Explanation:
Using lubricants such as oil or grease can reduce the friction between the surfaces
Is silicone a better conductor then silver
Answer: Silicon is better
Hope it helps!!
Embarking on a road trip, you hope to average a speed of 90.0 km/hr. Driving through bad weather, you finally reach the midpoint (half the distance) of your trip, but realize that you have only been averaging 5.0 X 10^1 km/hr. How fast would you have to drive the second half of the trip to keep your desired arrival time? *
Answer:
Explanation:
average speed = 90 km / hr
Let the total distance be 2 d .
time required to cover the time = 2 d / 90
time taken to cover distance d at 50 km /h = d / 50
time required to cover the nd half = 2 d / 90 - d / 50
.02222 d - .02 d = .002222 d
speed required = d/2 / .002222d
1 / 2 x .002222
= 225 km /h .
A car pulling out of a gas station accelerates from rest at a constant rate it covers 1200 meters in 30 seconds. What is the rate of acceleration
What is special about decomposers? *
a. they are autotrophs that absorb nutrients that have been digested outside their bodies.
b. they are heterotrophs that absorb nutrients that have been digested outside their bodies.
c. they are autotrophs that digest food internally (inside their bodies)
d. they are heterotrophs that digest food internally (inside their bodies)
A ball is projected horizontally from the top of a cliff and free falls to the ground.
Which one of the following statements accurately describes the ball's motion?
Please help!!
Why is it important to keep the mass (weight) of your car low?
Words to use:
Mass, inversely proportional (as mass goes up, acceleration goes down),
acceleration (to change motion), force
Answer:
Mass is the correct answer.
Explanation:
Many drivers report a more positive handling response and a definite improvement when reducing unsprung mass. You want to keep unsprung weight to as little as possible. This minimizes the momentum and energies that your suspension has to counter. In effect, it can make your shocks more sensitive.
Answer:
If you push hard, the block's bottom will move out from under its center of gravity and the block will tip over. The taller the block, the easier it is to push the bottom out from under the center of gravity. Keeping a car's center of gravity low is important to avoiding disaster during turns. But if you don't keep the car's center gravity low it will be inversely proportional and the acceleration can be damaged with force, and its mass could get disproportionate.
Explanation:
I'm sorry i tried my best. :/
Can someone please help me on this?
Answer:
80
Explanation:
what happens to the wave length and frequency of a wave as it crosses a different medium and speeds
Answer: SEE EXPLANATION!
Explanation:
When waves travel from one medium to another the frequency never changes. As waves travel into the denser medium, they slow down and wavelength decreases. Part of the wave travels faster for longer causing the wave to turn. The wave is slower but the wavelength is shorter meaning frequency remains the same.
I hope this helps you!
How fast would an inline skater have been traveling if he had covered 400 m in 10
seconds?
Answer:
The answer is 40 m/sExplanation:
The speed or velocity of an object given it's distance and time taken can be found by using the formula
[tex]v = \frac{d}{t} \\ [/tex]
From the question we have
[tex]v = \frac{400}{10} \\ [/tex]
We have the final answer as
40 m/sHope this helps you
When candle wax is heated enough, it becomes a liquid and flows. However, if it isn't heated, candle wax is a solid. Which of the following explains why liquid candle wax flows but solid wax does not?
○ the molecules of the Liquid wax are softer than the molecules of the solid matte wax.
○ The molecules of the liquid wax have less mass than the molecules of the solid wax.
○ The molecules of the liquid wax can easily move past one another but the molecules of the solid wax cannot.
Answer:
C
Explanation:
The formula for calculating density, D, is D=MV, where M represents mass and V represents volume.
For liquids, volume is often given in cubic centimeters (cc), which is the same as cm 3. If the density of an unknown liquid is 1.6 g/cc, what is the mass of 800 cc of the unknown liquid in grams (g)?
Answer:
Density 1.6g/cc means that every 1(one) cubic centimeter of the liquid has a mass of 1.6 grams.
Then, what about 800 cubic centimeters – how much mass, in grams, will it have ?
= 1.6 * 800 = 1280 g
Explanation:
What is a scientific theory?
Answer:
Scientific theories are explanations of some aspect of the natural world based on repeated observations.
Hope this helps!!!!
Answer:
The way that scientists use the word 'theory' is a little different than how it is commonly used in the lay public," said Jaime Tanner, a professor of biology at Marlboro College. "Most people use the word 'theory' to mean an idea or hunch that someone has, but in science the word 'theory' refers to the way that we interpret facts.
Explanation:
NEED HELP ASAP!!!
If 100 newtons of force are applied over a distance of 50 meters for 5 seconds, how much power is used
2,500 watts
1,000 joules
10 watts
1,000 watts
Answer:
2,500 watts
Explanation:
I got this answer right on a test. I hope it works for you to.
Answer:
2500 wats
Explanation:
How many joules of kinetic energy does the pendulum have when it has 50 J of potential energy?
Answer:
We do not have the information of the pendulum, so i will answer in a general way.
First, as you know, the total energy can be written as:
E = U + K
Where:
U = potential energy
K = kinetic energy.
Now, by the conservation of energy, we know that E does not change.
This means that if U increases an amount x, then K must decrease by the same amount.
Now, at the maximum height of the pendulum, the velocity is zero, this means that in this point the kinetic energy is 0j.
E = 0 + U
E = U.
Another thing that you may know about pendulums is that, if the initial displacement is by an angle θ, then the angle between the string and the vertical can never be more than θ.
And we know that:
U = m*g*h
in this case, we can write h, the maximum height, as:
h = L*(1 - cos(θ))
Where:
L is the length of the string, g is the gravitational acceleration and m is the mass of the pendulum.
Then the total energy of the pendulum is:
E = m*g*L*(1 - cos(θ))
And we had that:
E = K + U = m*g*L*(1 - cos(θ))
Then, if in a given point we have U = 50j, the kinetic energy must be:
K + 50j = m*g*L*(1 - cos(θ))
K = m*g*L*(1 - cos(θ)) - 50j
An object accelerates from rest to a velocity of 34 m/s
over a distance of 70 m. What was its acceleration?
Answer:
6.8m/s²
Explanation:
Given parameters:
Initial velocity = 0m/s
Final velocity = 34m/s
Distance = 70m
Unknown:
To solve this problem we apply one of the motion equations;
V² = U² + 2aS
where V is the final velocity
U is the initial velocity
a is the acceleration
S is the distance covered
Input the parameters and solve;
34² = 0² + 2 x a x 70
34² = 140a
a = 6.8m/s²
Mass
An object accelerated at a rate of 50 m/s/s. A force of
100 N was used to make this happen. What is the mass
of the object?
kg
HELP ME PLS
Answer:
2kg
Explanation:
100N = Force 50m/s²= Acceleration
Mass=?
the equation is;
Mass(kg)= Force(N) ÷ Acceleration (m/s²)
100÷50=2
. Exercises that specifically prepare the muscles for active movements
Answer:
Dynamic Stretching
Explanation:
Dynamic Stretching: Dynamic stretches are controlled movements that prepare your muscles, ligaments and other soft tissues for performance and safety.
13. How much dimmer than the sun is Eridani B2
Answer: Eridani B2 appears only [tex]6.73[/tex]×[tex]10^{-13}[/tex] as bright as the sun.
The weight of a box is having a mass of 100 kg is ___n
Answer: the weight of the box is 980N
Explanation:
The weight an object has is defined as the force of gravity acting on that object which is given as
w =m x g
Since weight is defined as a force, it can also be written as
w=mg
= F= mg
where m= mass of the object in kg given as 100Kg
an g is the gravitational acceleration in m/s^2 = g is 9.8 m/s2
F= mg
F = 100 kg x 9.8 m/s2
F== 980Kgm/s^2 = 980N
Therefore the weight of the box is 980N
from the list below, which athlete would need to focus on cardiovascular endurance?
A. Body Builder
B. Baseball Player
C. Marathon Runner
D. Bowler
Answer:
A. body builder
Explanation:
Which has more inertia?
A human or an elephant and explain why?
Answer:
A human
Explanation:
An elephant weighs more, therefore it's gravitational pull by Earth impacts it more than a human.
Hope this helps!
Have a nice day!
If you find my answer helpful
Pls consider marking my answer as Brainliest! It would mean a lot!
Answer:
Explanation:
Think of it this way: An elephant has more inertia than a human. It is much harder to push an elephant across a floor than it is a human, and much harder to stop the elephant once it is moving. Therefore, by definition, an elephant has more mass than a human.
A go cart engine applies a force of 888N and moves the cart forward 22m.
a) How much work is done?
b) We put on a bigger engine (1111N) but the cart still moves forward 22m. How much work is done now?
c) Why would you put on a bigger engine if you are still moving 22m?
Answer:
Explanation:
a) work=Force times distance. given force is 888N and distance travelled is 22M
work= 888 x 22 = 19536J or 1.954x10^5J
b) work = 1111 x 22= 24442J or 2.444x10^5J
c) putting on a larger engine means that there are gonna be more force applied to the go cart. therefore the cart will travel the same distance faster
a. The amount of work done by the go cart engine is 19,536 Nm.
b. The amount of work done when a bigger engine is used is 24,442 Nm.
c. The reason why a bigger engine is used is, so that the engine can easily do more work in the same amount of distance.
Given the following data:
Force A = 888 NewtonDistance = 22 meterForce B = 1111 Newtona. To determine the amount of work done by the go cart engine:
Mathematically, the work done by an object is given by the formula;
[tex]Work\;done = Force \times distance[/tex]
Substituting the given parameters into the formula, we have;
[tex]Work\;done = 888 \times 22[/tex]
Work done = 19,536 Nm.
b. To determine the amount of work done when a bigger engine is used:
[tex]Work\;done = Force \times distance[/tex]
[tex]Work\;done = 1111 \times 22[/tex]
Work done = 24,442 Nm.
c. The reason why a bigger engine is used is, so that the engine can easily do more work in the same amount of distance.
Read more: https://brainly.com/question/22599382
An object dropped from rest and falls a distance of 80 m.
What is the objects displacement
Answer:
Δx = -80m
Explanation:
The object's displacement is -80m because it landed 80m below where it started.
what does a worm and wheel mechanism do to torque and speed
Answer:Explanation:
Image result for what does a worm and wheel mechanism do to torque and speed
Like other gear arrangements, a worm drive can reduce rotational speed or transmit higher torque. ... Each full 360 degree turn of a single start worm advances the gear by one tooth. For a multi start worm the gear reduction equals the number of teeth on the gear divided by the number of starts on the worm.
"As long as the baseball I hit is
moving upward, there is no air resistance. Air resistance only slows it down when it is falling downward."
Answer:
Air resistance is always in play so it always has air resitance no matter what.
The temperature of a 5.0 kg block increases by 3 degrees C when 2,000 J of thermal energy are added to the block. What is the specific heat of the block? _____________
how many tennis balls are in 8 bags if each bag holds 25 tennis balls.
The answer is 200, 200 tennis balls would be in 8 bags if they each held 25.
Answer:
200 balls
Explanation:
All living things are made of one or more cells.
True
False
Answer:
the correct answer is false
Which of the following is not a force? *
gravity
friction
tension
acceleration
Answer:
tension
Explanation:
its a feeling
Which of the following statements is not true about genes?
A. Genes consist of hormones that regulate bodily functions.
B. Genes are DNA segments that are carried in each chromosome.
C. Genes serve as the biochemical units of heredity.
D. Genes operate in pairs and influence one's physical traits.
Answer:
A.) Genes consist of hormones that regulate bodily functions.
Explanation:
The statements (A), (B) and (C) are correct to explain the functions of Genes in a human body.
The given problem is based on the concept and fundamentals of Genes. Genes in a human body acts as a set of instruction that determine the likings of the organism, its appearance, and its behavior in its environment.
As per the above definition, Genes are the hormones that is responsible for the regulation of functions of body.Genes are made of a substance called deoxyribonucleic acid, or DNA. Moreover, it is a short section of DNA that contains instructions that tell the cells to make molecules called proteins.It is responsible for the transmission of hereditary from one biological unit to another, therefore it is known to serve as Biochemical unit for Heredity.Thus, we can conclude that the statements (A), (B) and (C) are correct to explain the functions of Genes in a human body.
Learn more about the Genes here:
https://brainly.com/question/8832859
