Answer:
E = 2.7 x 10¹⁶ J
Explanation:
The release of energy associated with the mass can be calculated by Einstein's mass-energy relation, as follows:
[tex]E = mc^2[/tex]
where,
E = Energy Released = ?
m = mass of material reduced = 0.3 kg
c = speed of light = 3 x 10⁸ m/s
Therefore,
[tex]E = (0.3\ kg)(3\ x\ 10^8\ m/s)^2[/tex]
E = 2.7 x 10¹⁶ J
Write your question here (Keep it simple and clear to get the best answer) a car accelerates uniformly from an initial velocity of 10m/s at 2m/s squre for 4s.What is the average velocity
Answer:
Average velocity = 18 m/s
Explanation:
Given the following data;
Initial velocity = 10m/s
Acceleration = 2m/s²
Time = 4 seconds
To find the average velocity, we would use the first equation of motion;
[tex] V = U + at[/tex]
Where;
V is the final velocity.
U is the initial velocity.
a is the acceleration.
t is the time measured in seconds.
Substituting into the equation, we have;
V = u + at
V = 10 + 2*4
V = 10 + 8
V = 18 m/s
two pins attracted by a bar magnet maintain a distance between their ends why??
Who do you think had the most influence on modern science: Descartes or Newton? And why? i'll give brainliest
Answer: Newton
Explanation:
Isaac Newton is viewed as one of history's most persuasive researchers. During his lifetime, Newton created the hypothesis of gravity, the laws of movement (which turned into the establishment of material science), another strategy for arithmetic known as analytics, and leap forwards in optics like the reflecting telescope.
tic energy
15.The energy changes that take place when a stone falls freely from rest to
the ground can be orderly arranged as
A. Kinetic energy → Potential energy
B. Sound energy → Potential energy
C. Potential energy
→ Sound energy
D. Potential energy
16.A ductile material is that which
→ Sound energy
→ Heat.
→ Kinetic energy → Heat.
→ Kinetic energy → Heat.
→ Kinetic energy → Heat energy
→ Sound.
Answer:
15. potential- kinetic -potential
16. I don't understand
Ductile materials are materials that can be drawn into wire e.g copper
Answer:
15.A
Explanation:
a falling objects posses kinetic energy whiles objects at rest has potential energy
Me file can walk a distance of 300 meters in 60 seconds. What is his speed
Answer:
5 m/s
Explanation:
use speed=distance/time
300/60=5
I NEED THIS RIGHT NOW, PLEASE HELP!!!
A pendulum has 12 cycles in 3 second. What is its frequency?
a.15Hz
b.4Hz
c.36Hz
d.9Hz
Earth is protected from meteorites by... (please help T-T 10 points)
a. the Moon
b. the atmosphere
c. other planets
d. the Sun
Three resistors of resistances, R1=10Ω, R2=5Ω, R3=20Ω are connected in a circuit in such way that same amount of current flows through them. Draw a circuit diagram showing the correct connections of the three resistors, a cell of 2.5V, an ammeter and a voltmeter across R3. Calculate the potential difference across R3.
Answer
Explanation:
As the three resistors are connected in series, the expression to be used for the
calculation of RT equivalent resistance
is:
RT = R1 + R2 + R3
We replace the data of the statement in the previous expression and it remains:
5 10 15 RT + R1 + R2 + R3 + +
We perform the mathematical operations that lead us to the result we are looking for:
RT - 30Ω
A lens 57.8 cm from an object
forms an image 38.5 cm from the
lens. What is the focal length of
the lens?
Answer:
23.11
Explanation:
accellus
The focal length of the lens is approximately 115.3 cm. The explaination is explained below.
To find the focal length of the lens, we can use the lens formula:
1/f = 1/v - 1/u
Where:
f is the focal length of the lens
v is the distance of the image from the lens
u is the distance of the object from the lens
Given:
v = 38.5 cm
u = 57.8 cm
Let's substitute these values into the formula:
1/f = 1/38.5 - 1/57.8
Now, let's calculate the right side of the equation:
1/f = (57.8 - 38.5) / (38.5 * 57.8)
= 19.3 / (2223.3)
≈ 0.008677
Now, we can find the focal length (f) by taking the reciprocal of both sides:
f = 1 / (0.008677)
≈ 115.3 cm
Therefore, the focal length of the lens is approximately 115.3 cm.
Learn more about lens on:
https://brainly.com/question/29834071
#SPJ2
3. The coefficient of kinetic friction between an object and the surface upon which it is sliding is
0.40. The mass of the object is 3,2 kg. What is the force of friction?
Answer:
2
Explanation:
HEEEEEEELLLLLPPPPPPP 20 points and Brainliest
Why do radio telescopes convert radio waves (analog signals) to electrical (digital) signals for analysis?
Select ALL that apply
a
To reduce signal interference
b
To protect the information from Aliens
c
Data is analyzed on a computer
d
To make the data safe to analyze
Answer:
C. Data is analyzed on a computer
Explanation:
Computers can analyze electrical signals, not radio signals. This means that the radio waves need to be converted to electrical signals to help the computer analyze the data.
Helppppppl!!!!!!!!!!!
Answer:
I think deposition of C is the oldest deposit
6. A plane took 3.55 hours to complete its flight. If the distance of the flight was 2840 kilometers, at what average speed did the plane travel? Include the correct unit for full credit.
Answer:
The average speed is 10,082
Explanation:
Do the formula
Distance * time = speed
2840 * 3.55
= 10,082
1. Give 3 examples of waves that carry small amounts of energy?
ANSWER:
Radio wavesMicro wavesInfrared wavesName two things that Arjun and Diya did to get accurate measurements of the angles in their experiment
Answer:
i dont know them
Explanation:
help
mention 5 benefits of recreation
Explanation is in a file
bit.[tex]^{}[/tex]ly/3a8Nt8n
1. Un móvil se desplaza 20m e invierte 8 segundos en hacerlo. ¿Cuál es su velocidad instantánea? 2. Un móvil parte a 3 metros después del origen y se detiene a 2 metros antes de este. Si demora 10 segundos en su desplazamiento. Calcular su rapidez.
Answer:
1) v = 2.5 m / s, 2) v = -0.5 m / s
Explanation:
For this exercise we will use the kinematics relations
1) velocity is defined by
v = [tex]\frac{dx}{dt}[/tex]dx / dt
this definition serves for the instantaneous and the average velocity if the displacements are linear in time
v = 20/8
v = 2.5 m / s
b) for this part we use
v = [tex]\frac{\Delta x}{\Delta t}[/tex]
Δx = x_f -x₀
we must place a reference system, where the direction to the right is positive
x_f = -2 m
x₀ = +3 m
Δx = -2 -3
Δx = -5 m
we calculate
v = -5 / 10
v = -0.5 m / s
this value is a scalar
What acceleration will a force of 20 newtons cause if applied to a go-kart with a mass of 20 kilograms?
ОА.
2 meters per second per second
OB
20 meters per second per second
O C.
1 meter per second per second
OD
10 meters per second per second
Answer:
1m/s is the acceleration used. C
Explanation:
please mark brainliest
What is the net force on the cart in the diagram?
--> 50N --> 75N
Answer:
15N
Explanation:
Look, this is easy maths all you have to do is subtract 75N from 50N.
Please give me brainliest.
Sincerely,
JA$ON
A hot-air balloon with a mass of 400 kilograms moves across the sky with 3,200 joules of kinetic energy. The velocity of the balloon is meters/second.
Answer:
4 m/s
Explanation:
KE =
Velocity of balloon will be 4 m/s.
!! Hope It Helps !!
first person to answer correctly will get brainlist
5. All the resistors in this circuit, the 18 Ω resistor included, are in parallel. The voltage drop across each resistor is the same, which is the equivalent to the potential difference of the battery. That is, 36 V [choice K].
6. The ammeter is in series with the branch containing a 12 Ω resistor. Since the voltage drop across this resistor is 36 V, the current in this branch will be I = V/R = (36 V)/(12 Ω) = 3.0 A [choice D].
7. The equivalent resistance of the circuit can be calculated as follows:
1/R = 1/12 + 1/9 + 1/18 = 1/4; thus, R = 4.0 Ω [choice G].
8. Electrical power can be defined as electrical work/time, and electrical work can be given by W = qV. If P = qV/t and q/t = I (charge flowing per unit time is equal to current), then P = VI. From Ohm's law, V = IR, and I = V/R. Substituting V/R for I in the power equation, P = V²/R.
For this circuit, the V = 36 V and R (the equivalent resistance) = 4.0 Ω. So, the power loss in the circuit is P = (36 V)²/(4.0 Ω) = 324 W [choice J].
How can red giants be so bright when they are so cool
Answer:
The star's luminosity rises above its previous level. Because it is so cool, the surface will be red, and it will be much farther away from the center than it was during the earlier stages of star evolution. Despite its lower surface temperature, the red giant has a large surface area, which makes it very luminous.
Which of the following is one dimensional
A.
acceleration
B.
velocity
C.
both velocity and acceleration
D.
speed
Answer:
A.
Explanation:
Speed and velocity both require more than one component to be solved but acceleration is independant.
Which of the following actions will decrease the gravitational force between two objects?
Increasing the mass of the objects
Increasing the density of the objects
Increasing the distance between the objects
Increasing the temperature of the objects
Increasing the distance between the objects
here's the Answer :
=》Increasing the distance between the objects.
since, gravitational force is inversely proportional to the distance between the objects, so if the distance increases the force will decrease.
[tex]gravitational \: force \: \: \dfrac{1}{ \alpha } \: \: distance[/tex]
Which is an example of a trace fossil?
animal burrow
skin of organism
preserved bone
petrified wood
Answer: The correct answer is A). Animal burrow because burrow fossils represent the preserved byproducts of behavior rather than physical remains, they are considered a kind of trace fossil. One common kind of burrow fossil is known as Skolithos, and the similar Trypanites, Ophiomorpha and Diplocraterion.
Animal burrow is an example of a trace fossil.
What is fossil?The preserved remnants of plants and animals that were submerged in sediments like sand and mud beneath ancient seas, lakes, and rivers are known as fossils. Any preserved sign of life that is typically older than 10,000 years is considered a fossil.
After death, soft body parts degrade quickly, while hard body parts, including bones, shells, and teeth, can be replaced by minerals that solidify into rock. Soft components like feathers, ferns, or other signs of life, such footprints or faeces, may also be preserved in extremely rare circumstances. Both less familiar fossils like ammonites and trilobites as well as microscopic-sized ones like single-celled foraminifera or pollen grains can be found in the remains.
What is trace fossil?A trace fossil, also known as an ichnofossil, is a record of biological activity preserved in the fossil record but without the actual preserved plant or animal remains. Contrasting with body fossils, which are the preserved remains of portions of an organism's body that were typically modified by later chemical activity or mineralization, are trace fossils. Ichnology, the study of such trace fossils, is the field of study of iconologists.
Learn more about geology here:
https://brainly.com/question/7978853
#SPJ6
What concept does the image above show?
How can you derive an expression for the block's centripetal acceleration in terms of mass and an angle, and physical constants, as appropriate?
Answer: cause yes they can
Explanation:
How does u know
When reading a nutrition label, sodium is typically measured in what unit?
1 grams
2 milligrams
3 ounces
4 inches
Answer:
2) Milligrams
Explanation:
Would the following reaction be endothermic or exothermic? Why?
CH4 + 02 --> CO2 + H2O + Energy
A. Exothermic because energy is a reactant
B. Endothermic because energy is a reactant
C. Endothermic because energy is a product
D. Exothermic because energy is a product
Answer:
Exothermic because energy is a product
Explanation:
Since energy is a product, heat was released, meaning that the reaction is exothermic.
