An object is pulled northward at 20 N and southward at 15 N. What is the direction and force of the object?
Answer:
It moves northward at 5N
Explanation:
A family is driving from Vancouver to Calgary, a distance of 907.3 km. During the first 300 km, they average 92 km/h. They stop for lunch for 38 min. They arrive in Calgary 8 h and 21 min after their lunch break.. What was their average speed (in km/h) for the entire journey, including the break?
Answer:
89 i would say
Explanation:
Calculate the weight of a 2.3 kg squirrel
Answer:
Lemme think rq
*inserts writing noises*
*insert intese thinking*
*insert big brain moment*
Well the weight IS 2.3 kg so I think the weight of a squirrel is 2.3 kg
Which ray diagram shows reflection
Answer:B
Explanation:
Answer:
The answer is B.
Explanation:
edge2020
Which phrase best describes what the graph for
average low temperatures would look like?
rk
O It would run parallel to and below the high
temperature graph.
O It would be a flat line that crosses the high
temperature graph.
O It would be the opposite of the high temperature
graph.
It would be a flat line below the high temperature
graph.
Answer:
i dont know sir
Explanation:
The weight of a cuboid box is 288 N. Find its mass.
Answer:
29.39 kg
Explanation:
From the question,
W = mg...................... Equation 1
Where W = weight of the cuboid box, m = mass of the cuboid box, g = acceleration due to gravity.
make m the subject of the equation
m = W/g.................. Equation 2
Given: W = 288 N
Constant: g = 9.8 m/s²
Substitute these values into equation 2
m = 288/9.8
m = 29.39 kg
pls help Which one of the following is NOT acceleration
A.
a change in mass
B.
a change in direction
C.
an increase in velocity
D.
a decrease in velocity
Answer:
C
Explanation:
Am increase in velocity?
Answer:
change in mass is not acceleration
As the signal turns green, automobile A accelerates at a constant rate of 2 m/s2. Two seconds later, automobile B starts and accelerates at a constant rate of 3.6 m/s2. Determine (a) when B will overtake A, (b) the speed of each automobile at that time, and c) the location where B overtakes A relative to the traffic signal.
Answer:
a) 45 s , b) vₐ = 90 m / s, v_b = 162 m / s, c) x_b = 3.328 10⁴ m
Explanation:
We can solve this exercise using the kinematic relations
Vehicle A
xₐ = v₀ₐ t + ½ aₐ t²
vehicle B
starts two seconds later
x_b = v_{ob} (t-2) + ½ a_b (t-2) ²
as cars start from rest their initial velocities are zero
at the point where they meet, the position must be the same for both vehicles
xa = 0 + ½ aₐ t²
xb = 0 + ½ a_b (t-2) ²
½ aₐ t² = ½ a_b (t-2) ²
[tex]\sqrt{ \frac{a_a}{a_b} }[/tex] t = (t-2)
t (1 - \sqrt{ \frac{a_a}{a_b} }) = 2
t (1 - ⅔, ) = 2
t = 2 / 0.4444
t = 45 s
b)
the speed of each car
vₐ = voa + aa t
vₐ = 0 + 2 45
vₐ = 90 m / s
v_b = 3.6 45
v_b = 162 m / s
c) xb = 0 + ½ ab (t-2) ²
x_b = ½ 3.6 (45-2) ²
x_b = 3.328 10⁴ m
What is Heat engine?
Answer:
An engine made of heat!
Okay actual answer, A heat engine is a mechanical energy converter that transforms heat or thermal energy to mechanical energy.
a car travels for two hours at an average speed of 36 km/h how far will the car travel
Answer:
259200
Explanation:
use the formula distance= speed x time
change the 2 hours to seconds (7200) and multiply that number by 36 and it'll give you 259200
Answer:
12 kilometers and hour
Explanation:
During which process does layer upon layer of sediment build up, exerting pressure on the layers below?
a. erosion
b. compaction
c. conglomerate
d. weathering
Which one of the following is an example of an indicator?
A. High Concentration
B. Electricity
C. Litmus Paper
D. Presence of H ions in solutions
Answer:
Litmus Paper
Explanation:
Answer:
A
Explanation:
well because I just answer that question too
So what is 27+22? Is it
A 8338
B 8282
C 8228
D 8234
Answer:
You put the add sign, so it would be 49. I don't believe that is what you meant to put though.
Explanation:
i gotchu, 27+22 so you take the 8 and multiply that by the number of times you blink every 2 minutes and then divide that by 0×1 and carry the 3 and that gives you -7
Can you please help me?
Answer:
2nd one
Explanation:
highest frequency shortest wavelength
Answer:
highest frequency shortest wavelength
Which statement compares the strengths of electric forces between particles of matter?
Please don't just guess for points, if your answer is wrong i'll report it.
A. Hydrogen bonds are stronger than ionic bonds but weaker than Van der Waals forces.
B. Metallic bonds are stronger than hydrogen bonds but weaker than ionic bonds.
C. Hydrogen bonds are weaker than Van der Waals forces but stronger than metallic bonds.
D. Metallic bonds are weaker than hydrogen but are stronger than ionic bonds.
B. Metallic bonds are stronger than hydrogen bonds but weaker than ionic bonds.
The statement is discussing the relative strengths of different types of electric forces that can exist between particles of matter.
Metallic bonds are formed by the sharing of electrons between atoms in a metal, and are considered relatively strong. Hydrogen bonds are formed between molecules that contain hydrogen and are relatively weak compared to metallic bonds.
Ionic bonds are formed between positively and negatively charged ions and are generally considered to be the strongest of these three types of bonds. Thus, the statement concludes that metallic bonds are stronger than hydrogen bonds but weaker than ionic bonds in terms of their relative strengths.
For more such question on hydrogen
https://brainly.com/question/2111051
#SPJ11
How long will it take a sample of lead-212 (which has a half-life of 10.64 h) to decay to one-eighth its original strength?
Answer:
31.92 h
Explanation:
We'll begin by calculating the number of half-lives that has elapsed. This can be obtained as follow:
Original amount (N₀) = 1
Amount remaining (N) = ⅛
Number of half-lives (n) =?
N = 1/2ⁿ × N₀
⅛ = 1/2ⁿ × 1
Cross multiply
2ⁿ = 8
Express 8 in index form with 2 as the base.
2ⁿ = 2³
n = 3
Thus, 3 half-lives has elapsed.
Finally, we shall determine the time. This can be obtained as follow:
Half-life (t½) = 10.64 h
Number of half-lives (n) = 3
Time (t) =?
n = t / t½
3 = t / 10.64
Cross multiply
t = 3 × 10.64
t = 31.92 h
Therefore, it will take 31.92 h for lead-212 to decay to one-eighth its original strength.
A cruise ship travels across a river at 25 meters per minute. If the river is 6200 meters wide, how long
does it take the ship to reach the other side.
Answer:
248 minutes
Explanation:
6200/25=248
This means there is 248 25s in 6200
which means it will take 248 minutes to travel through the river
Also here's a neat trick:
The units for speed is meters/minute
The units for distance is meters
Dividing distance by speed will cancel out the meters and leave only the speed.
What is sin(77°)? plz help
Answer:
Value of Sin(77 degree) = 0.97437006
Degree / Radian Function
(angle in degree) (angle in radian) Sin Cos Tan Cot Sec Cosec SinH CosH TanH CosecH SecH CotH Arc Sin Arc Cos Arc Tan Arc Cosec Arc Sec Arc Cot
True or False? Index Fossils are used to help constrain the relative age of the rocks in an area?
A family took a trip in a car traveling East from Greensboro to Wilmington, NC. Use the Graph to answer the questions below.
1: Calculate the average speed of the trip.
2: What was the average velocity of the car?
Note: Please don't put weird stuff or completely off-topic stuff, I really need help for this homework! Thanks!
Answer:
1). Average speed = 1.5 m per second
2). Average velocity = 1.5 m per second
Explanation:
1). Since, speed is a scalar quantity
Therefore, average speed of the trip = [tex]\frac{\text{Total distance covered}}{\text{Total time taken}}[/tex]
From the graph attached,
Total distance covered = 10 + 10 + 20 + 0 + 20 + 30
= 90 meters
Total time taken = 60 seconds
Average speed = [tex]\frac{90}{60}[/tex]
= 1.5 meter per second
2). Velocity is a vector quantity.
Therefore, average velocity = [tex]\frac{\triangle d}{\triangle t}[/tex]
= [tex]\frac{d_{60}-d_0}{60-0}[/tex]
= [tex]\frac{90-0}{60-0}[/tex]
= 1.5 meter per second
A. Dashed Line
B. Solid Line
A truck skids for a distance of 25m with the road pushing on its tires with force of 1500N as its brakes are applied. What is the change in kinetic energy for the truck?
Answer:
37500 J
Explanation:
Law of conservation of energy: Its states that energy can neither be created nor destroyed but it can be transformed from one form to another.
Applying the law of conservation of energy.
The change in kinetic energy for the truck = Net work done by the truck skids
ΔK.E = F×d.................... Equation 1
Where ΔK.E = Change in kinetic energy, F = Force, d = distant.
Given: F = 1500 N, d = 25 m
Substitute these values into equation 1
ΔK.E = 1500×25
ΔK.E = 37500 J
how can the conductivity of a semiconductor be increased?
Help me on this please
7. Your friend shows you a special kind of paper that can change color. He says that it will change
color if it is out in the sun. Can light from the sun cause the paper to change color?
a
Yes. Light from the sun can pull energy out of the paper, causing it to change color.
b
Yes. The paper can take in energy from the light, causing it to change color.
С
No. Light is not a physical thing, so it cannot change physical things like paper.
d
No. Light can only change things by warming them up, so it cannot cause the paper to
change color.
Answer:
d no light can only change things by warming them up , so it cannot cause the paper to change colur
a force of 2N exerted on a block causes it to accelerate at 4m/s^2 over a frictionless surface. calc the mass of the block
can someone help me plz
Answer:
Positive I believe... because if you drop it it is negative so picking up a book means positive. thanks for the points though!
Explanation:
Can I have brainliest please? <3
Objects A and B are brought close to each other. Object A will soon become positively charged. Identify the charge that must transfer for
this
situation to occur.
A piece of steel is 11.5cm long at 22C. It is heated to 1221C, close to its melting point. How long is it, in cm, at the high temperature?
Answer:
The length at the final temperature is 11.7 cm.
Explanation:
We need to use the thermal expansion equation:
[tex]\Delta L=\alpha L_{0}\Delta T[/tex]
Where:
L(0) is the initial lengthΔT is the differential temperature, final temperature minus initial temperature (T(f)-T(0))ΔL is the final length minus the initial length (L(f)-L(0))α is the coefficient of linear expantion of steel (12.5*10⁻⁶ 1/°C)So, we have:
[tex]L_{f}-L_{0}=\alpha L_{0}(T_{f}-T_{0})[/tex]
[tex]L_{f}=L_{0}+\alpha L_{0}(T_{f}-T_{0})[/tex]
[tex]L_{f}=0.115+(12.5*10^{-6})(0.115)(1221-22)[/tex]
[tex]L_{f}=0.117\: m[/tex]
Therefore, the length at the final temperature is 11.7 cm.
I hope it helps you!
using a diagram explain how acceleration can be obtained from a velocity time graph
Answer:
For any v-t graph the acceleration is the slope of the graph. For average acceleration in a time period ‘t’ consider the change in velocity in time t and divide it by the time t. For instantaneous acceleration you need to go into the realm of differential calculus.
Explanation:
I hope this helps! I would really appreciate it if you would please mark me brainliest! Have a blessed day!
