Answer:
The charge on a neutron=1+-/neutral
It has a mass 1
The charge on electron is 1-/negative
It's mass is 1/1840
The charge on a proton is 1+
It has a mass 1 too.
Explanation:
1. A teacher instructs her students to measure out 50.0 mL of hydrogen
peroxide for three trials of an experiment. A student measures out 37.2 mL,
38.7 mL, and 36.9 mL.
Use this information to answer the questions below (1a and 1b).
3 points
1a. Calculate the percent error for each measurement and include them
below. (For example: 1%, 2%, 3%) *
Answer:
by measuring the teacher gets to 1590
Explanation:
ndnmv drf
use the facts that water has a higher specific heat than rock (such as Granite) to explain the differences in the temperature curves for the two cities in the graph.
Since water has a high specific heat, that results in water being able to store/require more energy in order to change it’s temperature. Since San Francisco is so close to water, that would mean that it’s temperature should vary less since water would be able to keep the temperature around the same value even if there was an increase or decrease in thermal energy.
Describe how gasoline, as a fuel, can undergo a chemical change.
Answer with Explanation:
A "chemical change" occurs when the structure of the molecules change. If there's no change in structure, it is called a "physical change." This also means that a chemical reaction has to occur for something to be considered a chemical change.
Gasoline when used as a fuel is being transformed into other forms of energy. It undergoes a process called "combustion."
When used as a fuel for cars, the gasoline is being burned to produce heat energy. This energy is then converted into mechanical energy that allows the car to move. Clearly, the gasoline has undergone a chemical change.
Observe the nature changing around your home. You can observe plants, animals, and parts of your actual home as you begin to notice changes in matter. Collect data for two examples of changes in matter. Use the Changes in Matter observation questions to determine if your examples are physical or chemical changes.
Your answer should include two examples, the types of changes observed, and evidence of how the examples were formed. You can use this format:
Example 1:
Type of Change:
Evidence:
Answer:
Example 1. One change I observed was when cooking, I needed to boil water. The water was later evaporated due to the increase of heat from the stove below the pot. Heat traveled and transferred from the stove to the pot then the water. This change is from liquid to gas.
Example 2. I was mixing sugar into my tea, the sugar dissolved into the tea. This is an example of dissolving a solid into a liquid. The tea took the properties of the sugar and turned the drink sweet.
Extra, taking a hot shower and steam leaves the shower. This change is of evaporation.
Explanation:
Hope this helps, even though it was late! <3 :)
A chemical formula is given.
CO+C+0
What does the formula describe?
Answer:
carbon and oxygen
Explanation:
c stands for carbon and o stands for oxygen
Joe bought a roll of gray duct tape containing 5400 inches. If there are 5280 feet in a mile, how
many miles long is Joe's roll of duct tape?
Answer:
STANDARD: 0.085 mi, 450 ft, or 150 yds
METRIC: 0.137 km, 137.16 m, or 13716 cm
Explanation:
How is compound XY different from elements X and Y?
Answer:
Compound XY contains the different atoms of X and Y while elements X and Y both contains the same atoms of X and Y respectively.
Find the explanation below.
Explanation:
An element is a substance that is composed of atoms of the same kind. For example, element X contains only atoms of X while element Y contains only atoms of Y. On the other hand, a compound is a substance made from the chemical combination of two or more elements, hence, a compound combines different atoms. This is the case of Compound XY as it contains different atoms of different elements.
Therefore, Compound XY is different from elements X and Y in the sense that Compound XY contains two different atoms from different elements (X and Y) while both elements X and Y are individually made up of only one type of atom each i.e. element X contain X atoms only and element Y contain Y atoms only.
PLES help me for brainless
Answer:
a 1 doesn't belong
Explanation:
Gas has fast moving molecules.
Liquids have slow moving molecules.
Solids have vibrating molecules.
Which of the following is a clue that something is pseudoscience?
A
the presence of empirical evidence
B
the use of a famous athlete for support
C
the support of a respected scientist
D
the use of the scientific method
Pseudoscience has been the belief that are proportions that look scientific but are not. The use of the celebrated athlete for sponsorship is an example of pseudoscience. Thus, option B is correct.
What is pseudoscience?Pseudoscience has been defined as the claim and beliefs that are not testable and looks scientific but actually are not. They are the findings and propositions that can be considered scientific erroneously.
It includes subjective ideas and explanations based on various ideas and beliefs that are not proven scientifically. The use of an athlete for promotional and supporting a claim is an example of pseudoscience as the claim made is not proved scientifically but rather based on some famous person's statement.
Therefore, option B. the famous athlete for support is an example of pseudoscience.
Learn more about pseudoscience, here:
https://brainly.com/question/12257058
#SPJ2
Camilla is asked to provide an example of a physical change that can occur as a result of the addition of heat. Which of the following could Camilla describe?
Group of answer choices
Liquid turning to solid
Solids getting smaller
Liquids gaining mass
Solids turning to liquids
The complex K4[Zn(CN)4(O2)2] is oxidised into Kz[Zn(CN)4(O2)2], then which of the following is correct ?
(A) Zn(II) is oxidised into Zn(IV)
(B) Paramagnetic moment decreases
(C) O-O bond length increases
(D) Paramagnetic moment increases
Answer:
D
Explanation:
THE ANSWER ID DEFINITLY D
How would you obtain ethanol from rice starch?
Answer:
By putting the rice in water
Explanation:
what is ohm's law? in simple terms please. I dont know but This is what I said, formulas to determine the voltage, resistance or the current. Is this right?
Answer: Your answer was pretty close, but we could make it better! Simply put, ohm's law states that by doubling the voltage across a circuit, the current will also double. You could also say that it was a formula used to calculate the relationship between voltage, current and resistance in an electrical circuit, or (E = IR). Hope this helps!
Explanation:
Which table best summarizes the subatomic particles and their electrical charge?
H
F proton
negative
positive
no charge
neutron
electron
positive
no charge
negative
proton
neutron
electron
G proton
neutron
electron
positive
negative
no charge
proton
neutron
electron
no charge
positive
negative
Answer:
Proton - Positive charge
Neutron - No charge
Electron - negative charge
Explanation:
An atom is the smallest particle of matter that takes part in a chemical reaction.
It is made up of three fundamental subatomic particles.
Protons are the positively charged particles in an atom. Neutrons do not carry any charges and are neutralElectrons are negatively chargedBoth the protons and neutrons occupy a tiny center where the mass of the atom is concentrated. The region is called the nucleus.
what does it mean if elements are in the same group on the periodic table?
Answer:
mostly metals
Explanation:
just learned
Earth Layers: describe each layer of makeup, location, and physical properties.be sure to include which layers are compositional and watch are mechanical
Answer:
Ok so the earth layers are
Crust, the surface of the earth
Mantle, where the lava usually comes from or how volcanos form due to the tectonic plates moving
outer core
inner core is the hottest
if you are asking for the compositional and mechanical layers that would be
Crust, mantle, core, Lithosphere, Asthenoshpere, Mesosphere, out core, and inner core
Mechanical: Lithosphere, Asthenosphere, mesosphere, outer and inner core
Compostional: Crust, Mantle, and core
You just got a free ticket for a boat ride, and you can bring along
2 friends! Unfortunately, you have 5 friends who want to come along.
Answer:
10
Explanation:
Khan Academy
which force is a noncontact force
Answer:
A magnet attracting metal
what happens to the particles of a substance as it's temperature increases
A lead fishing weight of 39.7g is submerged in a graduated cylinder of water containing 75.0mL of water. The water level will increase to what volume in the cylinder?
Answer:
78.5 mL
Explanation:
Step 1: Given data
Mass of the lead fishing weight: 39.7 g
Volume of water in the graduated cylinder: 75.0 mL
Step 2: Calculate the volume of the lead fishing weight
The density of lead is 11.34 g/mL.
39.7 g × (1 mL/11.34 g) = 3.50 mL
Step 3: Calculate to what volume will increase the water level
The final volume of water will be equal to its initial value plus the volume displaced by the lead fishing weight.
V = 75.0 mL + 3.50 mL = 78.5 mL
George has several plants in his garden. Once in a while, he adds fertilizer to the soil. The leaves absorb the nutrients in the fertilizer and look healthy. If a cell is compared to a plant, which organelle helps transport fertilizer from the soil to the leaf?
Answer:
A vesicle. Vesicles are involved in metabolism, transport, buoyancy control, and temporary storage of food and enzymes
Orbital diagram for an iron atom
Solid formation begins with the weathering of ____?
Subsoil
Humus
Rock
Litter
Im giving brainliest to the correct answer
Answer:
The weathering of Rocks
Explanation:
C
if a baseball player hits a baseball from 4 feet off the ground with an initial velocity of 64 feet per second, how long will it take the baseball to hit the ground? use the equation h= -16t^2+4t + 4 round your answer to the nearest tenth hundredth
Answer:
4.06
Explanation:
What advances in technology helped usher in the scientific revolution? Choose the best answer.
1.The landing on the Moon by Apollo brought about the scientific revolution.
2.Discoveries by scholars in the Catholic Church revolutionized scientific knowledge.
3.The discoveries by ancient Greek, Muslim and Chinese scientists.
4.The discovery of optics gave scientists instruments such as microscopes and telescopes.
Answer:
The discovery of optics gave scientists instruments such as microscopes and telescopes.
Explanation:
The period between the 16th-8th century was called the period of the scientific revolution. At this time, the foundations of our modern science was laid.
One of the characteristic of this period was the emphasis on the scientific method which upheld results from reproducible experiments.
Nicolaus Copernicus, Francis Bacon and Isaac Newton were leading names in this period.
It was within this period that the discovery of optics gave scientists instruments such as microscopes and telescopes and scientific examination of the celestial bodies was launched.
Which choice is not an example of a molecule?
of the following which element is the heaviest? helium argon lithium aluminum
Answer:
Lithium
Explanation:
it is the only metal listed.
Acetone molecule polor or nonpolar?
What is the role for dna in determining an organisms traits?
Answer:
DNA contains the genes or the genetic material of an organism. Its role is to store information that are essential in controlling the genetic makeup or producing a certain characteristic of an organism.
Determine how you would prepare 220 mL of a 0.500 M potassium hydroxide solution starting with: a) solid potassium hydroxide b) a 1.25 M potassium hydroxide solution
Answer:
a) 6.17 g of solid KOH
b) 88.0 mL of a 1.25 M potassium hydroxide solution
Explanation:
a) We have to determine the mass of solid potassium hydroxide that has to be weighed to prepare 220 mL of a 0.500 M potassium hydroxide solution. We will also require the molar mass of potassium hydroxide, KOH, 56.11 g/mol.
0.220 L × (0.500 mol/L) × (56.11 g/mol) = 6.17 g
b) We will use the dilution rule to determine the volume of the 1.25 M potassium hydroxide solution to be measured.
C₁ × V₁ = C₂ × V₂
V₁ = C₂ × V₂ / C₁
V₁ = 0.500 M × 220 mL / 1.25 M = 88.0 mL
